50FT LED Flexible Indoor Strip Tape 24V DC
24V 15M LED Tape Flexible Strip Lighting
Cuttable with 3M two-sided tape
Ultra-thin has double-sided 3M tape for quick install, draws 1.8W/ft and emits 160 lumens per foot, comes in 50-foot spools translating into 18 SMD’s per foot this strip light comes in 2700K, 3000K warm light, and 4000K white light, ideally suited for cove, display and back bar lighting setting a required mood.
Fully dimmable using line voltage dimmable LED drivers or low voltage PWM LED dimmers and aluminium profiles (Please see our Accessories Page).
Display LED lighting
Back bar lighting
Ultra-thin flexible LED strip tape lights
Cut lines every 6 LEDs, for easy to cut on-site
Double-sided 3M tape
Simple to install
+50,000 hour lifespan, with 3 Year Warranty
LEDs can be cut every 3 LEDs at the marked locations and re-connected together by soldering or using solderless easy snap connects.
Solderless connectors make it easy to connect strips together after cutting, found on our accessories page.
Requires LED 24V DC Driver (click here )
1 x 50 foot LED tape spool with 750 Super Bright LED’S
3M tape on back for quick installation
||500 × .8 × .2 cm
1.8W per foot
|Degree of light spread
|Number of LEDS
60 SMDs/M (18/ft)
Warm White 2700K, Warm White 3000K, White 4000K
160 lumens per foot
W0.44 x H0.06 in.
|LED Strip Length
Surface or Recess mount
Request more information
Require more information? Please fill out the request form:
Frequently asked Questions:
Q: How do I cut strips to custom sizes?
A: A cut mark is indicated every three LEDs. Use scissors or wire strippers to cut along the indicated line
Q: Can I chain cut sections?
A: Solder points are located at the edge of each cut section. Two strips can be soldered together by removing the 3M tape from the back of one and placing the solder points over the top of the other strip’s solder points. Wire can be attached to link two strips the same way